Comtech EF Data CDM-IP Quick-Start Guide - Manual (Page 14)

CDM-IP Quick Start Guide Rev. 0
Getting Started CD/CDMIPQSG.IOM
12
This will erase any user configuration and restore the CDM-IP to factory default
configuration. Proceed to Section 1.2 to perform the EasyConnect
 Mode configuration
or to Section 1.3 to perform the Router Mode configuration.
1.2 E ASY C ONNECT

P OINT - TO -P OINT S YSTEM C ONFIGURATION
The steps in this guide will lead to following configuration:
IP Address:
Mask:
172.16.10.11
255.255.255.0
PC 1
Satellite IP Modem (CDM-IP 1)
Ethernet Interface (fei0)
IP Address:
Mask:
172.16.10.1
255.255.255.0
10 BaseT
Ethernet Hub
RF or IF
IP Address:
Mask: 172.16.10.12
255.255.255.0
PC 2 10 BaseT
Ethernet Hub
Ethernet Interface (fei0)
IP Address:
Mask:
172.16.10.2
255.255.255.0
Satellite IP Modem (CDM-IP 2)
Figure 2. EasyConnect
 Point-to-Point System Configuration
1.2.1 PC C ONFIGURATION
Step Description
1 Set the IP address on PC 1 to 172.16.10.11, mask to 255.255.255.0.
2 Set the IP address on PC 2 to 172.16.10.12, mask to 255.255.255.0.
3 Reboot the PCs (if required).
1.2.2 CDM-IP C ONFIGURATION
After restoring the factory default settings, the CDM-IP will be in EasyConnect
 Mode,
which will automaticaly put the CDM-IP in 10BaseT Half Duplex. Select Interface
Configuration\Ethernet Interface(fei0)
to verify the Speed Mode is 10 baseT Half
Duplex. If desired 10BaseT Full Duplex can be selected, but the CDM-IP will not allow
Auto Speed Mode or 100 BaseT when in EasyConnect
.