Comtech EF Data CDM-IP Quick-Start Guide - Manual (Page 11)

9
Chapter 1. Getting Started
Introduction ................................................ 9
EasyConnect
 Point-to-Point System
Configuration ...................................... 12
Router Mode Point-to-Point System
Configuration ...................................... 14
Troubleshooting IP Module ....................... 18
1.1 I NTRODUCTION
This quick start guide will allow a user to configure a pair of CDM-IP 550 or CDM-IP
300L (referred to as CDM-IP in rest of the document) from beginning (i.e. starting from
factory default settings) and be able to pass traffic within minutes. It is assumed that the
user is familiar with the configuration of the base satellite modem.
1.1.1 E QUIPMENT L IST
Following equipment is required:
Item Equipment Quantity Comments
1 CDM-IP Modem 2 Can be CDM-IP 550 or CDM-IP 300L
Note: CDM-IP 550 can be used with a
CDM-IP 300L, but customer will
need to provide equipment to
convert 70 MHz IF to L-band for
a duplex connection.
2 10/100 BaseT Ethernet Hub 2 Provided by customer
Note: Only 10BaseT operation is
supported in EasyConnect

mode.
RJ-45 crossover Ethernet cables can be
substituted to directly connect PC to
CDM-IP modem without the use of a hub.
3 PC with NIC and a terminal
emulation program 2 Provided by customer
4 Console cable (DB-9 to RJ-11) 1 Supplied by Comtech EF Data
5 Ethernet cables (CAT 5) 4 Provided by customer
6 IF cables 2 Provided by customer
(To interconnect TX-RX between both
CDM-IP modems.)