CompX eLock Latch Upgrade - Manual (Page 4)

Refrigerator Kit
4
CompX eLock • compx.com
Step 6 – RefuRbiShing the elock
Gather the following parts. They are all needed to refurbish the
refrigerator lock. They are (from left to right):
k Main access control assembly with latch cable installed.
k RJ11 connector/cable assembly
k Battery pack
Step 7 – ReinStall batteRy box
Place the battery holder into the new refrigerator lock housing such that
the left side sits flush and the tab on the battery holder fits nicely into
the refrigerator lock housing. Ensure tab of battery box is in position
shown; cable is not pinched.
Housing mUST sit inside groove of battery pack in two locations
BEFORE snapping the battery pack in.
InSIde VIeW
Step 8
After battery pack is properly aligned, press on the right side of the
battery pack to snap it in.
Step 9 – ReinStall the bezel
Place main access control assembly onto refrigerator lock housing
as shown, ensuring that the cables line up with the opening in the
refrigerator lock housing.