CompX eLock Network Fridge - Manual (Page 6)

6
CompX eLock Instructions continued
Below are the FACTORY DEFAULT SETTINGS for eLocks
equipped with temperature monitoring.
NOTE:
1) Permission Levels can only be changed using LockView
software.
2) Permission Levels checked in gray scale cannot be changed.
Provided no Permission Level changes have been made
in LockView, Supervisor status is required to adjust the
following settings via manual programming at the eLock:
Reset Min/Max observations
MIN/MAX OBSERVATIONS IS THE THE HIGHEST AND LOWEST
TEMPERATURE THAT HAS BEEN RECORDED SINCE THE LAST
TIME THE eLock WAS RESET. THIS WILL NOT RESET THE UPPER
AND LOWER LIMITS FOR ALARMING.
At the eLock, press the “UP” button to view the highest
observed temperature or the “DOWN” button to view the
lowest observed temperature recording since the last reset
Set upper/lower limits
UPPER/LOWER LIMITS IS THE HIGHEST AND LOWEST
ACCEPTABLE TEMPERATURE. THE TEMPERATURE RANGE CAN
BE ADJUSTED IN 1/10TH DEGREE INCREMENTS.
The temperature range of a:
Standard Temp eLock: -40°C to 100°C (-40°F to 212°F)
Ultra Low Temp eLock: -100°C to -40°C (-148°F to -40°F)
Set alarm volume
OFF, SOFT, MED, LOUD
Enable/disable the alarm
TURN ALARM ON/OFF
Permission to “Enable/disable the alarm” requires that
permission to “Open while alarm is sounding” is also
granted.
Provided no Permission Level changes have been made
in LockView, BOTH Users* and Supervisors may adjust the
following settings via manual programming at the eLock:
Select Display Formats
HOURS: AM/PM or 24 HOUR
DAY/DATE: MON-SUN MM/DD/YY; MON-SUN MMM D ‘YY;
MON-SUN DD-MM-YY; MON-SUN DD-MMM-YY or MON-SUN
YYYY-MM-DD
TEMP: °FAHRENHEIT or °CELSIUS
Open while alarm is sounding
A VALID CREDENTIAL WILL BE ALLOWED TO OPEN AN eLock
WHILE AN ALARM IS SOUNDING.
*In order for User status credentials to be permitted to
open an eLock while an alarm is sounding, permission for
Supervisors to do so must also be granted.
Mute the alarm
THE ALARM MUST BE TRIGGERED AND THE RECORDED
TEMPERATURE MUST BE OUTSIDE OF THE ACCEPTABLE
PROGRAMMED RANGE IN ORDER SEE THIS FEATURE
Mute can be used to silence a triggered alarm for 10 minutes.
(see Manual Programming Guide for details)
NOTE:
Alarm Delay and Alarm Time can only be adjusted via
LockView.