CompX eLock Network Fridge - Manual (Page 4)

4
CompX eLock Instructions continued
Methods to begin building
a database of eLocks in
CompX’s LockView Software
Note: Supervisor, User and parameter changes that already
exist in the eLock will automatically be carried into
LockView once the eLock has been enrolled.
For Networked (802.11g or Ethernet) eLocks, please
follow the CompX eLock Database & Network Configuration
& Install Manual and the CompX LockView Software
Instruction Manual before proceeding.
LockView Mode Instructions
(For complete details on how to build a database of users
and eLocks, see the CompX LockView Software Instruction
Manual and CompX eLock Manual Programming Guide)
CompX LockView Software v4.1 must be installed and the
eLock must be in SETUP mode before continuing.
Stand-alone eLocks (Direct USB connection to laptop
computer with LockView is required) There are two methods
that can be used to add eLocks to the LockView software.
Automatic Method
1) With the eLock in SETUP mode, connect the eLock via the
USB cable to the computer on which LockView is installed.
2) Login to LockView.
3) After 30 seconds, the below will appear.
NOTE: After 5 minutes of inactivity, the eLock will exit SETUP
mode.
4) Click Yes.
5) The below will appear.
Type in the name of the lock.
**Once a Lock Name has been chosen in LockView, it can
not be changed. Please be sure the name that is chosen is
the one that will be used in the future.
6) Click Save when done.
7) Go to Lock Editor tab in Lock/User Editor.
8) Left click to highlight the name of the lock and then click Edit
Lock.
9) Verify and/or adjust all other lock parameters. (See LockView
Instruction Manual for complete details.)
10) Click OK when done.
Manual Method
1) Login to LockView.
2) Go to Lock/User Editor; Lock Editor tab and click Add
Lock.
3) Enter the required information: Lock Name; Lock Serial
Number and Setup Code (supplied on green sticker set as
Setup Cd).
**Once the Lock Name has been chosen in LockView, it can
not be changed. Please be sure the name that is chosen is
the one that will be used in the future.
4) Verify and/or adjust all other lock parameters and click OK.
(See LockView Instruction Manual for complete details on
these options)
5) With the eLock in SETUP mode, connect the eLock via the
USB cable to the computer on which LockView is installed.
6) After 30 seconds, the lock will be updated in LockView. Click
Refresh to prompt the update.
NOTE: After 5 minutes of inactivity, the eLock will exit SETUP
mode.