CompX eLock Network Fridge - Manual (Page 2)

2
CompX eLock Instructions continued
Unit Features:
w Choose 802.11g or Ethernet Networked configurations that
uses the facilities existing infrastructure for actual 2-way
read/write communication
w Each eLock can hold any combination of up to 3,000
Supervisors and Users
w Choose a model to use existing HID Prox, HID iCLASS, or 3
track magstripe card credentials that can be programmed to
operate each eLock
w View, print and download a 15,000 event access audit trail
via the LockView Software (see LockView Instruction Manual
for complete audit trail details)
w View, print and download a 500,000 event temperature
audit via the LockView Software (temp monitoring required)
(see LockView Instruction Manual for complete audit trail
details)
w Standard Temperature Monitoring eLock
-40ºC to 100ºC (-40º F to 212º F)
w Ultra Low Temperature Monitoring eLock
-100º C to -40º C (-148º F to -40º F)
w Accuracy within +/- 0.5º C (temp monitoring required)
w NIST certification available (temp monitoring required)
w Interactive 128 x 64 dot matrix LCD with blue backlight that
adjusts to 3 different angles for easy viewing
w Remote Notification System with programmable escalating
alerts via SMTP email; SMS text, voice and fax (Networked
eLock & LockView Software required)
w Spring bolt latching mechanism provides automatic
relocking
w Optional second latch drive output (requires additional
hardware)
w Door position switch input (requires additional hardware)
w Membrane keypads with stainless steel domes provides
durable performance and easy cleaning
w Detachable mounting plate simplifies installation
w Choose from 3 different mounting configurations (vertical,
horizontal right hinge, horizontal left hinge) that will fit most
refrigerators, freezers, and incubators
What’s in the box?
w 1 – eLock
w 1 – eLock mounting plate
w 1 – strike (8” for standard or 14” for ultra low)
w 1 – strike plate cover
w 8 – #8 x 3/8” Phillips flat head mounting plate sheet metal
screw
w 2 – #8 x 1/2” Phillips pan head strike plate sheet metal
screw
w 2 – #8 x 1/2” pin-in Torx flat head strike plate cover machine
screw
w 2 – 7 1/2” x 1” strike plate foam tape
w 2 – 5 1/2” x 1” mounting plate foam tape
w 1 – 4 1/2” x 1” mounting plate foam tape
w 4 – adhesive backed temperature cable mounting clip
(temperature monitoring only)
w 1 – adhesive backed temperature probe mounting clip
(temperature monitoring only)
w 1 – battery cover that includes knock-out for Ethernet (if
equipped) and AC power adapter (not included)
w 1 – warranty card
w 1 – serial code sticker set
w 1 – in-box instructions
What’s needed?
w T15 pin-in Torx (6-lobe) bit or driver
w 6 AA alkaline batteries
w ruler or tape measure
w drill (if screws will be uses as the method of attachment)
w pencil
Care and Cleaning
The eLock is a battery operated device, therefore, it should
be part of a regular battery maintenance program.
To clean the surface of the eLock, apply non-acid based
cleaner to a clean cotton cloth; do not spray cleaner directly
on the eLock. Wipe down keypad and housing taking care
around the beeper opening and edges of keypads. Wipe
excess cleaner off of all surfaces.