CompX eLock Network Fridge - Manual (Page 12)

12
Installing the VERTICAL mount refrigerator kit
Mount the strike
at least 4" from
NON-hINGED EDGE
of the refrigerator.
There are two main parts of this installation: installing the strike and installing
the eLock assembly. The strike and the eLock assembly can be mounted either
with foam tape or by drilling holes and using screws. It is important to note that
mounting the strike and the eLock assembly are independent of each other. One
can be foam tape mounted, and one can be drill mounted if desired. The two do
not need to be mounted using the same method.
• verify eLock operation before beginning instaLLation •
a. Screw one tamper resistant sheet metal
screw into the center of the strike's slotted
area.
Note: The end of the metal strike
needs to curve up.
b. Place the plastic strike cover over the
metal strike. If strike was mounted using
foam tape, please proceed to Step 3.
c. Attach with one tamper resistant machine
screw.
Install the strike
Step
1:
Secure the strike and attach the strike cover (if strike was mounted using foam tape, ONLY do b.)
Step
2:
Foam Tape Installation
: Option A
Please note that if foam tape installation
of the strike is used, the strike will
not
be adjustable once it's put in place.
a. Clean the top refrigerator as well as the
strike with rubbing alcohol. Wait for the
alcohol to dry.
b. With a pencil, mark refrigerator 6-7/8"
from the front of the door and at least 4"
from the non-hinged edge.
Measure from this line to the front of the
cabinet (dim. “A”); cut a piece of tape
this length.
c. Remove tape backer and affix to end
of strike. The upward curve should be
on top. Apply tape to the opposite side.
Remove backer. Line up strike with line on
refrigerator; apply pressure to seal it on.
Note: The end of the metal
strike needs to curve up.
Option B
Option A
Drilling Installation
: Option B
a. Before drilling, verify that there are no
refrigerant lines inside the top of the
refrigerator.
b. Drill a 9/64” hole, 5-7/8” from the
edge of the front of the refrigerator and
at least 4” from the non-hinged edge of
the refrigerator.