D-Link DES-5200 - Manual (Page 114)

Fast Ethernet Switching System User’s Guide
Web Management
107
A confirmation panel is shown when the settings are changed. See Figure 64.
Figure 64: Switch Port Configuration Confirmation
State
All ports have two states: enabled or disabled. Enabled ports transmit and receive
data packets. Disabled ports can not transmit or receive packets. You can disable
ports. However, you will not be able to use a disabled port.
Physical
Refers to the physical state of the port. If you manually change the state of a port
it will remain in that state until you change it. It will not auto negotiate speed and
duplex mode. All TX ports can be in the following physical states:
•
Auto
•
100Tx/Half
•
100Tx/Full
•
10Tx/Half
•
10Tx/Full
Ports in the Auto state automatically negotiate speed and duplex mode. This is the
default setting.
Ports set in the 100Tx/Half physical state are set to work at 100 Mbps half duplex.