DAVIS DriveRight 600E OBD Installation Guide (8126OBD) - Manual (Page 9)

7
7. Use the in-line butt splices to connect the blue wires with fuses to the
Green (Digital Input 1) and Yellow (Digital Input 2) wires from the
adapter cable.
8. Connect Digital Input 1 to the desired circuit.
9. Connect Digital Input 2 to the desired circuit.
10.Connect the digital input cable to the OBD cable.
It is easiest to make the connection by first holding the OBD cable
connector by the housing. Then hold the adapter connector on the
cable itself next to the sliding connector housing and push the two
connectors together. The two cables will lock together when prop-
erly connected.
Note: To disconnect the cables, hold the both cables by the housing and pull apart. The
sliding housing on the adapter cable connector will release the lock and allow the
cables to be separated.
Procedure 3: Install the DriveRight Console
1. The DriveRight console can be mounted in a number of places,
including the top of the dash, on the face of the dash, or on a sun
visor. Some of the different mounting choices are illustrated below
and on the following page:
Face of Dashboard Mounting Options
Sliding
Connector
Housing
Adapter Cable OBD Cable
To Connect Cables,
Hold as Shown Here
Mounting
Bracket
Double-Sided
Foam Tape
OR
Flat Head Self-Tapping Screw (2x)
Mounting
Bracket