Caple C981G - Manual (Page 5)

5
INSTRUCTIONS FOR THE INSTALLER
To install the hob, proceed as follows:
- Remove the pan supports and burners from the hob.
- Turn the appliance upside down and fit gasket (S) around the outer edge (fig. 3).
- Place the hob in the unit opening and fix it with screws (V) of brackets (G) (fig. 4).
Installation environment
This appliance is not equipped with a combustion products exhaustion system. Fumes must
therefore be exhausted to outside the building by means of an extractor hood or extractor fan
designed to start as soon as the appliance is set into operation.
The room in which the appliance is installed must be naturally ventilated to allow correct gas
combustion and room ventilation; the minimum volume of air required is 20 m 3 .
Fresh air must be drawn through permanent vents in the walls communicating with the exterior.
Ventilation may also be supplied via an adjacent room in compliance with standards in force.
Wall vents must have a minimum surface area 200 cm 2 .
Gas Connection
Make sure that the appliance is set up for the available gas type (see the label under the appliance).
Follow the instructions indicated in “Gas conversion and adjustment” if the appliance must be
adapted for use with different gas types.
The appliance must be connected to the gas supply by means of a rigid metal pipe, in compliance
with standards in force, or a seamless flexible steel pipe in compliance with standards in force.
Certain models are supplied with two unions:
a cylindrical union (A) and a conical union (B) (fig.5). Choose the appropriate union according to the
country of installation.
The weight of the connecting pipe must not be borne by the gas train.
Once installation is complete, apply a soapy solution to the seal to check that it is gas tight.
3
4 5