beautypg.com

Instructions for the installer, Installation – Caple C981G User Manual

Page 4

background image

4

INSTRUCTIONS FOR THE INSTALLER

INSTALLATION

Installing the hob

The appliance is designed to be built-in to a heat-resistant kitchen unit.

Kitchen unit side walls must be able to withstand temperatures of up to 75°C higher than room

temperature, in accordance with European regulations.

It is permissible to install the appliance next to a kitchen cabinet extending above the worktop on

one side only, either to the right or left. Any adjacent cabinet must be no less than 50 mm from the

edge of the hob.

The appliance must not be installed near inflammable materials, such as curtains, cloths, etc.

Cut an opening in the top of the kitchen unit observing the dimensions shown in fig. 1, maintaining

a distance of at least 50 mm between the edge of the appliance and adjacent walls.

MODEL

L (mm)

P (mm)

C981G

750

480

C1081G

950

365

If the hob is to be installed beneath a wall-mounted kitchen cabinet, ensure there is a minimum
clearance of 760 mm between the worktop and the underside of the cabinet.
It is good practice to isolate the appliance from the cupboard below in the kitchen unit by means of
a separator, leaving a well space of at least 10 mm in depth. (fig. 2).
If the hob is installed over an oven, precautions must be taken to guarantee installation in
accordance accident prevention standards. Pay particular attention to the position of the electric
cable and gas supply hose: they must not touch any hot parts of the oven. Moreover, if the hob is
installed over an oven without a forced cooling system, to ensure adequate ventilation air vents
must be provided with lower intake surface area of at least 200 cm

2

and upper outlet surface area

of at least 60 cm

2

.

Fixing the hob

Each hob is supplied with a special gasket and a set of brackets to be used for securing it to the

worktop.

IMPORTANT NOTICE:

THE OPERATIONS INDICATED BELOW MUST BE CARRIED OUT BY QUALIFIED PERSONNEL ONLY, IN

CONFORMITY WITH STATUTORY LEGISLATION.

THE MANUFACTURER DECLINES ALL LIABILITY FOR INJURY TO PERSONS OR ANIMALS OR DAMAGE

TO PROPERTY DUE TO FAILURE TO COMPLY WITH THESE PRESCRIPTIONS.

1

2

This manual is related to the following products: