Caple C981G - Manual (Page 15)

15
INSTRUCTIONS FOR THE USER
Touch panel unlock
5 5 5 5 5
To unlock the touch panel, press the “key” button and the “+” button of the LH burner for at
least 2 seconds. When the touch panel is unlocked the decimal points switch off in the power level
displays.
Programming burner off time
Each burner can be programmed to operate for a specified time, after which it switches off
automatically.
To program the timer of a specific burner, press
the “timer” button. The position of each burner is
shown by means of a LED on the control panel. The
LED will illuminate to indicate that the burner has
been selected for programming. Select the burner
with which to associate the timer using the “+”
and “-” buttons. The timer display will show 00.00,
meaning that the timer of the selected burner is not
activated.
00.00
Press the “key” button again. The flashing digits on the left of the dot indicate the hour and the
digits on the right indicate the minutes. Increase or decrease cooking time from 0 to 9 hours using
the “+” and “-” buttons. Hold down the “+” or “-” button to increase or decrease the hours digits
rapidly. To set the minutes, press the “key” button again. The digits on the right of the dot start
flashing. Set the minutes as described above for the hours.
When programming the cooking time you can cancel the current setting at any time by pressing the
“+” and “-” buttons simultaneously.
If the time is set to zero, the timer is deactivated. To confirm the time displayed, press the “key”
button.
At this point the indicators exclusively of the burners with active timer will continue flashing.
Press the “timer” button to access programming mode and display the time remaining before the
burner switches off or change the current setting. If no button is pressed for more than 10 seconds,
the system automatically quits programming mode and restores the main display. Any settings in
progress on the selected burner are retained and the associated timer remains active. The timer can
be programmed with the burner OFF or ON, and it will start counting from when the set cooking
time is confirmed. Once the set cooking time has elapsed, the timer-controlled burner will switch
off and a series of beeps will be emitted. Switching off a burner also deactivates the associated
timer (if programmed).