Caple C981G - Manual (Page 17)

17
INSTRUCTIONS FOR THE USER
Turning off all burners
To turn off all burners simultaneously, briefly press the ON/OFF button: the appliance will enter
standby mode.
Setting the clock
After a power failure, the hob clock must be reset.
To set the clock, simultaneously press and hold the
buttons shown in the figure for at least 3 seconds.
The flashing digits on the left of the dot indicate
the hour and the digits on the right indicate the
minutes. Increase or decrease the hour using the “+”
and “-” buttons.
Hold down the “+” or “-” button to increase or
decrease the hours digits rapidly.
To set the minutes, press the button with the clock
symbol again. The digits on the right of the dot will
start flashing; set the minutes as described above.
Press the button with the clock symbol again to save
the set time.
08.00
Burner reset
The burners may lock out due to external faults (for example, in the event of either a power or gas
supply failure).
The display of each locked out burner will show the letter “b”. To reset the burners, simultaneously
hold down the “-” and “key” buttons as shown in the figure for at least 2 seconds.
Once the burners have been reset, they will be set to level 0, ready to be turned on again.
N.B.: If you repeat the reset procedure 5 consecutive times within 15 minutes, the message FLT06
will be displayed and no other reset requests will be accepted for the following 15 minutes.
Touch panel lock
To activate this function, press the “key” button
for at least 2 seconds. All burner power levels will
remain in their current status. When the touch panel
is locked the decimal points light up in the display
of each burner. When the touch panel is locked, it
is not possible to change the burner power levels or
change the timer settings, but it is possible to switch
the hob off by pressing the ON/OFF button. Locked
burners cannot be reset when the touch panel lock is
activated. The touch panel must be unlocked before
performing the burner reset procedure.
5.