Caple CR1001SS User Manual
Page 16
16
REPLACEMENT OF THE BURNERS AND SWITCHES
- To replace these accessories, remove the hob following the se-
quence of instructions in Fig. 22 - 23 - 24
- To take the burners apart follow the sequence of instructions in
Fig. 31-32.
1) unscrew the lock nuts “C” and “D” and screws “E” (Fig. 31)
2) with the burner free turn and unscrew screws “F”.
REPLACEMENT OR FITTING OF POWER SUPPLY CABLE
Follow the advice below: (see Fig. 33)
- Remove the rear panel of the cooker by unscrewing screws “B”
- Connect the power supply cable selecting the type indicated in
the table on page 16/17 “ELECTRICAL CONNECTION”
- Replace the rear panel using the same procedure in reverse.
COMMENTS
The earth conductor must be longer than the active conductors.
fig. 33
fig. 32
fig. 31