Campomatic C964XRSIFSCN - Manual (Page 9)

9
� �
�
�
�
�
�
�
�
�
�
�
ELECTRONIC CLOCK WITH COOKING TIME
This timer has two different functions: a clock function
and one that automatically stops the oven by setting
the length of cooking time.
The digital display always shows the time but will also
show timer time when this function is set.
Setting the time (from 0.01 to 24.00 = hh,mm)
After connecting to the electricity mains or subsequent
to a power cut either the figures “0.00” or the time
elapsed since electricity was returned, will flash on
the display. Press push button 1 and start setting the
current time by pressing button 2 or 3.
While you are setting the time the manual functioning
mode symbol will turn on. The function will start 7
seconds after setting.
Manual operation
By simply setting the time (push button 1) or when
the buzzer is interrupted (push button 3) the timer is
programmed on the manual functioning mode which
is confirmed when the symbol turns on. To the
contrary, the manual functioning mode is only possible
at the end of semi-automatic programming or after
having cancelled it.
Semi-automatic operation (with cooking time from
0.01 to 0.99 = hh,mm)
By selecting the time on the minute counter with push
button 3 this function will always be active (the time is
set in 10 second units).
The time will disappear from the display leaving the
minute counter time and the symbol showing and
the AUTO symbol will turn on. The time units are in
seconds during count down.
At the end of the set time the buzzer will ring, the AUTO
and symbols will turn off and the time reappears.
The time can be seen during this function by pressing
push button 1.
Buzzer
The buzzer goes off at the end of the minute counter
function and lasts about 7 minutes. The buzzer can be
stopped by pressing button 3. After having done this
remember to turn the selector knob and the thermostat
round to the off position.
Buzzer intensity
There are three different buzzer intensities: to select
the one you want press push button 2 when the time
is displayed. Manual function programming is now
cancelled.
Correcting/cancelling functions
To correct or cancel the time set on the timer, press
keys 2 and 3 simultaneously and then release key
3 first. The time can be corrected at any moment by
pressing push button 1 followed by 2 or 3.
DESCRIPTION OF THE APPLIANCE