Campomatic C964XRSIFSCN - Manual (Page 35)

35
��
�
��
�
CHANGING THE FLEXIBLE GAS HOSE
In order to guarantee that the gas hose is always in excellent condition we strongly recommend changing it on
the date you will find printed on it.
REPLACING THE ELECTRICAL COMPONENTS
• The rear protection will have to be removed in order to change the electrical heating elements, spit motor,
terminal board and power cable.
• If you have to change the power cable (see the cross section on table on page 27), always keep
the earth wire longer than the phase wires and, in addition, follow all the instructions given in the
«ELECTRICAL CONNECTION» paragraph.
• To change the oven lamp see the instructions on page 23.
• To change the lamp holder type 1 (fig. 15), remove the side panels and then use a screwdriver to push the
two locking tabs (fig. 34) and remove the lamp holder from the inside of the oven.
• To change the lamp holder type 2, the spark generator and the spark electrodes, the work top has to be
removed as indicated in paragraph «REPLACING THE TAPS AND THERMOSTAT».
• To change the lamp-holder type 2 (fig. 16), unscrew the protective glass cap (C), force the tabs of blockage
and take the lamp-holder toward the inside of the oven.
• To change the eventual programming accessory, the thermostat, the commutator and the indicator lights,
remove the front panel as indicated in paragraph «TAPS»
• To change the hob electrical heating elements, remove the hob, unscrewing frontal and rear fixing screws (Vs)
(fig. 35) which lock the hob at the supports (S).
INSTRUCTIONS FOR THE INSTALLER
�
�
34
35