Campomatic C964XRSIFSCN - Manual (Page 23)

23
�
�
� �
�
17 16 18
�
�
16a
STRUCTURE
All the cooker parts (in enamelled or painted metal, steel, or
glass) should be cleaned frequently with warm soapy water
and then rinsed and dried with a soft cloth.
DO NOT use rough or abrasive materials or sharp metal
scrapers to clean the oven glass doors as they could scratch
and cause the glass to break
NEVER use sponges or abrasive products, and aromatic or
aliphatic solvents to remove stains or adhesives on the painted
or stainless steel surfaces.
OVEN CAVITY
Do not spray or wash the thermostat bulb with acid
based products (check the product label before use).
The manufacturer cannot be held liable for any damage
caused by incorrect cleaning.
The oven cavity should be cleaned after each use
to remove cooking residuals and or grease or sugar
which, if burnt on when the oven is used again, will
form deposits or unremovable stains as well as
unpleasant smells.
To maintain the shine of the enamelled parts, clean
them with warm soapy water, rinse and dry them
thoroughly. ALWAYS wash the accessories used.
OVEN SEAL
The oven seal guarantees the correct functioning of
the oven. We recommend you:
• clean it, avoiding abrasive tools or products.
• check its state now and then.
If the oven door seal has become hard or is damaged,
contact our Service Centre and avoid using the oven
until it has been repaired.
OVEN SIDE-GUIDE RAILS (fig. 16 )
For an effective cleaning of the oven side-guide rails,
these can be extracted unscrewing knurled nuts (G).
To fit the rails back in their place, first insert rear pins in
holes and then secure them with the knurled nuts (G).
3. INSTRUCTIONS FOR THE USER
or (fig.16a)
1. Push with a finger on the last of the slots to release
the grid from its hold.
2. Lift it towards the top and extract the grid.
To put them back into place, reverse the order of this
operation.
REPLACING THE OVEN LAMP
Ensure the appliance is switched off before
replacing the lamp to avoid the possibility of
electric shock..
In the event one or both oven lamps need replacing, the
new lamps must comply with the following requisites:
15 W - 230 V~ - 50 Hz - E 14 - and must be resistant
to high temperature (300°C).
The appliance can have two different types of lamp
holder:
• Lamp holder type 1 (fig. 17): Draw out the side
guide rails as described above.Then, remove the
glass protection cap (V) from the bulb socket, lifting
it with a screwdriver placed between the cap and
the oven wall and replace the lamp (L). Fit the
accessories back in reverse order.
• Lamp holder type 2 (fig. 18): Turn glass protection
cap (C) counterclockwise and change the lamp.
Re-fit the cap, screwing it back in a clockwise
direction.