Campomatic C964XRSIFSCN - Manual (Page 12)

12
7 6
HOB: GENERAL NOTES ON SAFETY
• When using the burners or the heating elements, do
not leave the appliance unsupervised. Ensure that
children do not play with the appliance. In particular,
make sure that pan handles are positioned correctly
and supervise the cooking of foods which use oils
and fats, as these are highly inflammable.
• Do not use aerosols or sprays near the appliance
when it is in use.
• If the appliance is fitted with a lid, remove any food
residues on the surface before opening.
• If the appliance is fitted with a crystal glass lid, this
can shatter when heated. Turn off all the burners or
disconnect all heating elements and to attend that
is cooled, before closing the lid (fig. 6).
• Even after use, the burners or the heating elements
remain hot for a long period; to avoid burning, do
not place hands or other objects on them (on the
ceramic glass hobs, pay attention to the “residual
heat warning”).
• If a crack appears on the surface of the ceramic
glass or electric plate, disconnect the appliance
from the electricity supply immediately.
• After using the appliance, ensure that all the controls
are in the closed or off position.
When a gas cooker is being used it produces heat
and humidity in the room where it is installed.
For this reason the room must be well ventilated,
keeping the natural ventilation openings free (fig.
19) and switching on the mechanical aeration
system (suction hood or electric fan, figs. 20 and
21). If the cooker is used for a long time additional
aeration may be necessary, for instance, opening
a window, or a more effective aeration by
increasing the power of the mechanical system
if there is one.
INSTRUCTIONS FOR THE USER
LIGHTING THE BURNERS
a) Manual ignition
Press and turn counterclockwise the knob (C)
corresponding to the burner you wish to use, until it
reaches to the “Full on” position and placing a lighted
match to the burner.
b) Electric ignition of the burners
(only certain versions)
Press and turn counterclockwise the knob (C)
corresponding to the burner you wish to use, until it
reaches to the “Full on“ position and simultaneously
press and release the ignition button . Matches can
be used to light the burners in a blackout.
c) Automatic electric ignition of burners
(only certain versions)
Push lightly the knob (A) corresponding to the burner
you wish to use and turn counterclockwise to the
“Full on“ position, then depress the control knob.
Automatically the ignition spark shoots. Matches can
be used to light the burners in a blackout.
d) Lighting of burners equipped with safety
thermocouples (only certain versions)
In the case of burners equipped with safety
thermocouples you have to turn counterclockwise to
the “Full on“ position, the knob (C) corresponding to
the burner you wish to use, then press the knob and
repeat the operations described previously. Once lit,
keep the knob pressed for about 10 seconds.
e) Optimum use of the burners
To get the maximum yield with the minimum
consumption of gas it is handy to keep the following
points in mind:
• Once the burner has been lit, adjust the flame
according to your needs.
• Use an appropriately sized pan for each burner (see
the table below and fig. 7).
• When the content of the pan start to boil, turn
the knob down to “Reduced rate position” (small
flame).
• Always put a lid on the pan.
Burners Ø pan cm
Ultrarapid 22÷24
Rapid 20÷22
Semi-rapid 16÷18
Auxiliary 12÷14