Bronkhorst FLOW-BUS interface - Manual (Page 7)

BRONKHORST ®
Below are several examples how to build a FLOW‐BUS system. The principle of the FLOW‐BUS system is the same for
an IP40 or a IP65 system.
1. EL‐FLOW with E‐7000 2. CORI‐FLOW with E‐7000
FLOW
mass flow meter/controller
End
Terminator
7.03.321
Y-adapter
7.03.319
Cable RJ45 to M12
Begin
Terminator
7.03.298
FOR LIQUIDS AND GASES
CORI-FLOW
Digital Mass Flow Meter/Controller
BRONKHORST
HI-TEC
FLOW
R
Y-adapter
7.03.241
Page 7 FLOW‐BUS interface 9.17.024
The last instrument on the bus needs a bus‐end‐termination connector (black).
The first module on the bus (either an E‐7000 module for digital instruments or a FLOW‐BUS interface
module to a PC) needs a bus begin – terminator (red).
3. Four EL‐FLOWS with E‐7000