BDI 8200 Alcove - Manual (Page 7)

Install Flat Panel mounting brackets using (F x 8) on the front of the stand. The
height position can be adjusted up and down along the length of holes as needed
to accommodate your desired viewing height and your specific TV.
Step 5
Center channel
speaker grommet.
Designed to allow
passage of wire
connections and
then grommet
drops into place.
F x 8
H x 1
Upper
Bracket
Lower
Bracket
Brackets have 5 holes on
each side to allow fine-tuning
of TV hanging position.
Position 1” thick
Styrofoam from
original packaging
on top of cabinet
to protect it dur-
ing assembly and
installation of TV.
This step is best performed with one (1) person holding the bracket
in place from the FRONT of Alcove and one (1) person installing
the bracket fasteners from the REAR of Alcove. Position 1” thick
Styrofoam from original packaging on top of cabinet to protect it
during assembly and installation of TV.