BDI 8200 Alcove - Manual (Page 6)

Back panels are installed by placing them in upper groove on inside back
of cabinet then lifting and dropping them into the lower groove.
Step 4c
B - black x 2
B - black x 2
I
I
Secure curved panel from inside CD towers using (B - black x 2) and hex wrench
(I). You will use 1 (B –black) in each CD tower.
Step 4a
Secure bottom of curved panel from inside of cabinet using (B - black x 2) and
hex wrench (I).
Screws should be completely tightened and flush or below the bottom surface.
Step 4b