BayTech RPS Single-phase Combined - Manual (Page 18)

RPS with or without Ethernet
18
Change Unit ID
Select “Change Unit ID” from the configuration menu. The RPS will display the following:
The default ID is the unit’s number, in this case RPS26ADEN
Change Alarm Threshold
The Current Alarm Threshold allows the user to set the current level for the internal alarm to sound.
This setting is only available on units with current monitoring circuitry.
Select “Change Alarm Threshold.” from the configuration menu, The RPS will display the following:
Unit ID: BT RPS26ADEN-16
-------------------------------------------------------------------------------
-------------------------------------------------------------------------------
| Group | Current | Current | Voltage | Power | Amps |
-------------------------------------------------------------------------------
| Phase A1 | 0.2 Amps | 0.3 Amps | 210.1 Volts | 0 Watts | 43 VA |
| Phase A2 | 0.3 Amps | 0.3 Amps | 210.1 Volts | 0 Watts | 70 VA |
| Phase B1 | 0.2 Amps | 0.2 Amps | 1.4 Volts | 0 Watts | 4 VA |
| Phase B2 | 0.2 Amps | 0.2 Amps | 1.4 Volts | 0 Watts | 4 VA |
-------------------------------------------------------------------------------
Int. Temp: 95.9 F
Switch 1: Open 2: Open
1)...Outlet A/B 1 2)...Outlet A/B 2 3)...Outlet A/B 3
4)...Outlet A/B 4 5)...Outlet A/B 5 6)...Outlet A/B 6
7)...Outlet A/B 7 8)...Outlet A/B 8 9)...Outlet A/B 9
10)...Outlet A/B 10 11)...Outlet A/B 11 12)...Outlet A/B 12
13)...Outlet A/B 13 14)...Outlet A/B 14 15)...Outlet A/B 15
16)...Outlet A/B 16 17)...Outlet A/B 17 18)...Outlet A/B 18
19)...Outlet A/B 19 20)...Outlet A/B 20 21)...Outlet A/B 21
22)...Outlet A/B 22 23)...Outlet A/B 23 24)...Outlet A/B 24
Type Help for a list of commands
RPS-26>
Current Unit ID: BT
Modify (Y/N)? y
Enter New Unit ID: BT RPS26ADEN-16
Phase A1 buzzer alarm value : 8.0 Amps
Modify (Y/N)? Y
Phase A2 buzzer alarm value : 8.0 Amps
Modify (Y/N)? 10
Phase B1 buzzer alarm value : 8.0 Amps
Modify (Y/N)? 10
Phase B2 buzzer alarm value : 8.0 Amps
Modify (Y/N)? 10