BayTech RPS Single-phase Combined - Manual (Page 13)

RPS with or without Ethernet
13
If the current user already has a password the RPS will display the following:
NOTE: If you do not have the user’s current password, delete the user. Reinstall user. Select
option to change password and the RPS will respond asking for a new password.
Identify Current User
Type ‘whoami’ at the prompt to determine the current user, the RPS displays the following:
To change the user logout of the unit and log back in using the new user name.
Unit Identification
Type ‘unitid’ at the prompt to determine the Unit ID, the RPS displays the following:
To change the unit ID, go the Outlet Configuration menu and select ‘Change Unit ID’ option. The
maximum field length is 32 or 16 for older units.
RPS Configuration Menu
To select the configuration menu, type ‘config’ at the prompt.
User Management
The User Menu allows the admin user to add and delete users, change passwords, and change the
outlet list that displays a user’s access to prescribed outlets. Select “Manage Users,” from the
configuration menu and the following menu appears if the unit has been reset or initial setup:
Current User: root
Enter old Password:
Enter new Password:
Re-Enter new Password:
Unit ID: BT RPS26ADEN-16
Unit ID: BT RPS26ADEN-16
1)...Manage Users
2)...Change Outlet Name
3)...Enable/Disable Status Menu
4)...Change Unit ID
5)...Change Alarm Threshold
X)...Exit
Enter Request: