BayTech RPS Single-phase Combined - Manual (Page 10)

RPS with or without Ethernet
10
Detail Operations and Configurations
Opening Menu Status
IMPORTANT: The Factory default serial communications parameters are 9600 bps, 8 data
bits, 1 stop bit, and no parity; B/C switch set to ‘B’.
With a proper connection to the unit upon power-up or unit reset, the following initialization and
Status menu will be displayed except the number of outlets will be dependent on the specific RPS unit:
NOTE: The outlet user sees only those outlets as assigned to him by the admin user.
Type ‘HELP’ at the RPS prompt will display a list of commands to change the state of the outlets, unit
configuration, and internal sensor measurements.
Unit ID: BT RPS26ADEN-16
-------------------------------------------------------------------------------
| Phase | True RMS | Peak RMS | True RMS | Average | Volt- |
| Group | Current | Current | Voltage | Power | Amps |
-------------------------------------------------------------------------------
| Phase A1 | 0.2 Amps | 1.3 Amps | 209.9 Volts | 0 Watts | 43 VA |
| Phase A2 | 0.3 Amps | 0.4 Amps | 209.9 Volts | 0 Watts | 75 VA |
| Phase B1 | 0.2 Amps | 0.2 Amps | 1.5 Volts | 0 Watts | 4 VA |
| Phase B2 | 0.2 Amps | 0.2 Amps | 1.4 Volts | 0 Watts | 4 VA |
-------------------------------------------------------------------------------
Int. Temp: 92.3 F
Switch 1: Open 2: Open
1)...Outlet A/B 1 2)...Outlet A/B 2 3)...Outlet A/B 3
4)...Outlet A/B 4 5)...Outlet A/B 5 6)...Outlet A/B 6
7)...Outlet A/B 7 8)...Outlet A/B 8 9)...Outlet A/B 9
10)...Outlet A/B 10 11)...Outlet A/B 11 12)...Outlet A/B 12
13)...Outlet A/B 13 14)...Outlet A/B 14 15)...Outlet A/B 15
16)...Outlet A/B 16 17)...Outlet A/B 17 18)...Outlet A/B 18
19)...Outlet A/B 19 20)...Outlet A/B 20 21)...Outlet A/B 21
22)...Outlet A/B 22 23)...Outlet A/B 23 24)...Outlet A/B 24
Type Help for a list of commands
RPS-26>help