Basler Electric BE1-11 DNP3 Protocol - Manual (Page 76)

70 9424200773 Rev A
Point Index Description
0 43-1 Mode
1 43-2 Mode
2 43-3 Mode
3 43-4 Mode
4 43-5 Mode
5 101 Mode
6 Breaker Monitor Operations
7 Breaker Monitor Duty A
8 Breaker Monitor Duty B
9 Breaker Monitor Duty C
10 Demand Meter Reset Demands
11 DNP Save Assigned Class and Deadband
12 Fault Report Selection Record
13 Contact Output 1 Override Enable
14 Contact Output 2 Override Enable
15 Contact Output 3 Override Enable
16 Contact Output 4 Override Enable
17 Contact Output 5 Override Enable
18 Contact Output A Override Enable
19 Major Alarm Reset
20 Minor Alarm Reset
21 Targets Reset
22 Relay Alarms Reset
23 Settings Group Mode
24 Settings Group Operate
25 Demand Meter CT Circuit 2 Reset Current Demands
26 Demand Meter CT Circuit 2 Reset Ground Current Demands
27 Contact Output 6 Override Enable
28 Contact Output 7 Override Enable
29 Contact Output 8 Override Enable
30-32 Reserved
33 Logic Alarms Reset
8-Bit Unsigned Integer, Object 110
Table 7 is the point list for Object 110, and lists the 8-Bit Unsigned Integer Points. Note that this object
has only variation 1 and cannot be requested with default variation 0.
Point List BE1-11