D-Link SECURICAM NETWORK DCS-5300 - Manual (Page 9)

9
Hardware Installation
Connect an Ethernet cable
Connect an Ethernet cable to the network
cable connector located on the DCS-5300’s
back panel and attach it to the network.
Attach the external power supply
Attach the external power supply to the DC
power input connector located on the
DCS-5300’s back panel labeled 12VCD
and connect the other end to your wall outlet.
The Internet Camera comes with a camera
stand with a swivel ball screw head that
can be attached to the Internet Camera
bottom socket cavity. Attach the camera
stand to the Internet Camera and station it
for your application. There are holes
located in the base of the camera stand
allowing the Internet Camera to be mounted
to the ceiling, or any wall securely.
Attaching the Internet Camera to the Camera Stand
When you have a proper connection, the LED will turn from red to green . If you
are directly connected to the camera via a crossover cable, the light may cycle
on and off and your computer may show an intermittent loss of connectivity.
This is normal until you have configured your Internet Camera.