D-Link SECURICAM NETWORK DCS-5300 - Manual (Page 103)

103
Using IP surveillance Software (continued)
Scheduling (continued)
Hour Time-Line
In the figure below, the Hour time-line is displayed.
Marking/Unmarking the Recording Time on the Hour Time-Line
You can apply the one-click function by clicking the left mouse button and
dragging to mark the time on this time-line. The operating method for the hour
time-line is the same as that of the week time-lines. Please refer to the previous
section about marking/unmarking on the week time-line for more details
.
Schedule with Time Picker
Begin and End Time
Date picker Hour picker Minute picker
There are three controlling units in both “Begin Time” and “End Time” selectors
shown above. The first unit of these two selectors is the date picker. You can
select day with it to set the beginning time and the ending time for the recording
interval.
The second and third units are the hour picker and the minute picker. You can
change the hour and minute settings for the beginning and ending time with
them.
NOTE: The time set in “Begin time” must be earlier than that in “End time”.
Otherwise the settings will not be applied.