D-Link SECURICAM NETWORK DCS-5300 - Manual (Page 52)

52
Enable IR Control -
Click this to allow the DCS-5300 to be controlled by
the included remote.
Configuration > Advanced >Camera Control (Continued)
Current Position - Enter a name for the position at which you would
like to preset the DCS-5300. Click Add to add the
new preset position to the Preset Locations list.
Preset Position - Using the pull down menu, you can delete a preset
position by selecting it and clicking Delete.
Dwelling Time -
Set the value of time that the camera will remain on
each preset position before moving to the next. The
dwelling time can be set between 1 and 255
seconds.
Patrol Selection -
To use the Auto Patrol feature, select the desired
preset positions from the Preset Locations list and
add them to the Selected Locations list by clicking
Select
. You can then select the order in which the
camera will patrol through the preset locations
by selecting a location and clicking UP or DN.
Click Remove to remove a location from the list.
Click Apply to make
changes effective
Using the DCS-5300 with an Internet browser
(continued)