D-Link SECURICAM NETWORK DCS-5300 - Manual (Page 59)

59
Configuration > Tools > Default
Click on the Default button to access the factory setting restoration and
camera calibration options from the Tools menu.
Click Apply on the screen to restore factory default settings. This means any
changes made will be lost and the system will be reset to the initial status when
shipped from the factory. After confirmation, the system will restart and require
the Installation Wizard software program to locate the IP address of the DCS-
5300.
Using the DCS-5300 with an Internet browser
(continued)
Click Apply to make
changes effective
Configuration > Status > Device Info
Click on the Status tab to access Device Info and a Log of DCS-5300 system
activity. The Device Info is the default screen when you click on the Status
tab.
Click Default
Click Apply under Calibrate to restore them camera’s factory lens position.
This means that the camera will be recalibrated to the default center to position
to recover from any external forces that may have affected it.