Baja Motorsports WD400-U Operator's Manual - Manual (Page 54)

50
How to Initially Charge the battery:
1. Connect the red positive (+) cable to the red positive
(+) pole of the battery.
(see figure 24)
2. Connect the black negative (-) cable to the black
negative (-) pole of the battery. (see figure 25)
Note: The red positive (+) cable has a larger diameter
than the black negative y cable.
3. Charging rate: Charge battery @ 0.7 Amps for
5 ~ 10 hours.
• After charging is complete, press down firmly
with both hands to seat the caps, (Do not pound
or hammer). The battery is now sealed. (see
figure 26 )
• Install battery into battery compartment. The
battery terminals should be facing the front (see
figure 27)
• Once battery is firmly seated in battery
compartment attach the red positive wire to the
red positive terminal on the battery. (see figure 28)
• Then attach the black negative wire to the black
negative terminal on the battery.
(see figure 28)
• Install the battery bracket (see figure 28)
WARNING
NEVER REMOVE THE STRIP OF CAPS
NOR ADD ANY WATER OR ELECTROLYTE.
Figure 24
Figure 25
Figure 26
Figure 28
Figure 27
Red +
Black -
Battery bracket