Baby Lock Crown Jewel II (BLCJ18-2) Manual - Manual (Page 17)

10
Figure 5
Figure 4
Installing Front Handles
CAUTION: Unplug the Baby Lock Crown
Jewel II from the electrical outlet. All power
to the machine must be turned off when in-
stalling the front handles. Failure to do so can
result in damage to the machine.
IMPORTANT NOTE: Care must be taken to
not pinch the ribbon cable under the handle
when it is tightened to the machine.
Locate the three longest Allen screws and the
5.0mm Allen wrench. To install the handles, tilt the
screen forward. Line up the three holes on top of
the handles with the pre-drilled holes on top of the
machine. Slide a star washer onto the Allen screw,
then slide a bolt into each hole until it stops. Hand
tighten, and then use the 5.0mm Allen wrench to
securely fasten the handles to the machine
(Figure 4).
Once the Allen screws are in place, plug the ribbon
connector into the serial port on the left-hand side
of the machine (Back-Side Diagram B, #20 on
page 7 and Figure 5). Make sure the pins are
lined up so they are not damaged when the plug is
pushed in. Push the plug securely in place.