Note, Interactive configuration, Connecting the monitor and keyboard to the printer – Avery Dennison SNAP Ethernet Configuration User Manual
Page 3: Accessing the interactive configuration menu
Interactive Configuration
In order to use the Interactive Configuration, you must connect a monitor and
keyboard to the printer. These are the same standard PC components that are used
on desktop PCs.
Connecting the Monitor and Keyboard to the Printer
1. Turn the printer off.
2. The connector panel is located on the back right of the printer. Connect the
monitor to the video connector. This connector looks similar to the serial prot
connector, but it has 3 rows of pins instead of 2.
3. Connect the keyboard to the keyboard port. There are two round connectors at
the far left of the connector panel (looking at the back of the printer). The
keyboard connector is the bottom one.
Accessing the Interactive Configuration Menu
1. Turn the monitor and printer on.
2. The printer initialization will appear on the monitor. When the message “Press
F1 for Setup” appears, press the F1 key on the keyboard. A window will
appear asking for a password. Enter IP followed by the Enter key
3. A menu of commands will appear. Each command may be used to either view
the current setting or enter a new setting.
4. To view the current setting, simply enter the command followed by the Enter
key. The current value will be displayed.
5. To enter a new value, type the command followed by the value, then press the
Enter key. For example, to set the IP address to 168.1.1.0, type IP 168.1.1.0
and press the Enter key.
6. If at any time you need to refresh the command list, type HELP followed by
the Enter key.
7. The SMTP address is for email, which is not implemented in current versions.
8. The TCP/IP value must be set to ENABLED.
SNAP Printer Ethernet Configuration_V10.doc
Page 3 of 6
NOTE
Entries are not case sensitive. All commands may be
entered in either upper or lower case.