Avery Dennison Monarch 9906 Knife - Manual (Page 3)

Setting the Cut Position
This function adjusts where the knife cuts the supply. Use this setting to fine tune where the cut is
made. Drastic cut position changes could cause supply errors.
The adjustments are in dots (0.0049 inch).
 Increase the number to feed more supply out of the chute.
 Decrease the number to feed less supply out of the chute.
This option takes effect when you print the next tag.
To change the cut position setting, from the Main Menu, select Setup, Supply, Positioning.
1.
Press  or  until you see Cut Pos.
POSITIONING
← Cut Position →
0
CHANGE BACK
2.
Press CHANGE to highlight the cut position options. The current setting is shown.
3.
Press  or  to increment/decrement the cut position.
Note:
Pressing the left function button changes the increment/decrement amount (changes
by 1, 10, or 100).
POSITIONING
Cut Position
[-99/99] 0
1 SET CANCEL
5.
When you see the cut position you need, press SET to save the change. Press CANCEL to
leave the supply position unchanged.
4.
Press BACK until you return to the Home/Online screen.
POSITIONING
← Cut Position →
0
CHANGE BACK
3