Avery Dennison 7410 Network Card Setup Guide - Manual (Page 3)

3
When the printer is turned on, the print server runs through a set of power-
up diagnostics for a few seconds. If the print server is operating properly,
all three LEDs blink momentarily and then go out. Then, the LEDs come on
to indicate the following activity:
Yellow LED = Ethernet Link
Green LED = Activity
Red LED = Wireless Link
C o n f i g u r i n g t h e P r i n t S e r v e r
1. Start your Web Browser.
2. Type in your printer’s IP Address and press Enter/Pause. For example,
192.0.0.192.
Using MonarchNet2, the printer’s status is “Ready” when there is no
error on the printer. However, the printer may not be ready to
accept data. Make sure the printer’s display shows “Print Mode
Ready.”
Note: A MonarchNet2 manual is available and included in the licensing
fee. Contact your sales representative for more information.
P r i n t i n g a C o n f i g u r a t i o n L a b e l
To print a configuration label, press the Test button on the side of the
Ethernet print server unit.
Note: Use 6-inch long supply. If you are using supply that is shorter than
6 inches long, temporarily change your supply type to “continuous”
to print the entire test label. After printing the test label, change
your supply type to your previous setting. If the label is too small,
some information may print outside the label edges.