Important battery safety information, Battery life, Important battery safety information -3 – Avery Dennison Monarch 9876 User Manual
Page 13: Battery life -3
The 24VDC charger has a power LED and five percentage LEDs. When the charger is turned
off (power LED off), the percentage LED shows battery status. The percentage LED flashes
while charging to display battery status. When the batteries are fully charged, the 100 percent
LED stays on.
Charging the Batteries 3-3
Note:
The 24VDC charger power LED is always on regardless of whether the MWS power
switch is on or off.
I m p o r t a n t B a t t e r y S a f e t y I n f o r m a t i o n
Never smoke or allow a spark or flame in vicinity of battery.
Do not
drop a metal tool on the battery. The resulting spark or short-circuit on the battery
of other electrical part may cause an explosion.
Remove personal metal items such as rings, bracelets, necklaces, and watches when
working with a lead-acid battery. A lead-acid battery produces a short-circuit current high
enough to weld a ring to metal, causing a severe burn.
B a t t e r y L i f e
If you leave the battery charger plugged in and constantly charging when the MWS is not in
use (turn MWS power off)
, the battery life is maximized for the application. The charger does
not overcharge the batteries.
The MWS has signal lights to indicate the battery status as follows. The following voltages are
nominal (not exact) and should be used for reference.
M W S P ow er Sw it c h
P ow er L E D
P er c e n ta g e LE D s