beautypg.com

About the battery status leds, About the battery charger, About the battery status leds -2 – Avery Dennison Monarch 9876 User Manual

Page 12: About the battery charger -2

background image

If using an extension cord, you must use 18 gauge or heavier for lengths up to 50 feet, or
16 gauge or heavier for lengths up to 100 feet. Use of improper extension cord could cause
fire and electric shock. Use an extension cord bearing the UL listing mark and rated for
four Amperes or greater current capacity.

Pull on the plug rather than the cord when disconnecting the battery charger. Locate the
cords where they will not be stepped on, tripped over, or otherwise subjected to damage or
stress.

The batteries must be charged when the total voltage is less than 21V. The charger will not
charge if the total voltage is less than 5V. If the total voltage is less than 5V, you need new
batteries.

A b o u t t h e B a t t e r y S t a t u s L E D s

The charger is mounted on the Power Panel. The MWS Battery
Status LEDs are located on the top-left side of the Power
Panel. To use the Battery Status LEDs, the MWS must be on.

3-2

Operating Instructions

Store the charger in a dry area not subject to prolonged
below freezing temperatures.

The “intelligent” battery charger monitors the batteries
condition and does not overcharge the batteries. It is
recommended to leave the battery charger plugged in and
charging when the MWS is not in use. Battery life is
extended by frequent charging.

The charger’s Power On light is on when all the connections
are correct.

The charger’s Green Full Charge light is on when the
battery is finished charging. Leaving the charger plugged in prevents the battery fro
discharging.

m self-

The MWS Battery Status LEDs provide the most accurate indication of battery status. While
the 24VDC charger has Percentage LEDS that also show battery status, use the three
Battery Status LEDS on the Power Panel.

A b o u t t h e B a t t e r y C h a r g e r

When charging the batteries with the MWS powered Off, use the charge indicator on the left
side of the charger. The 12VDC and 24VDC chargers display battery status differently.

The 12VDC charger’s bi-color LED displays the following:

Orange

Charging process has
started (fan on).

Flashing Green (Slow)

Charging is in process,
but not fully charged.

Green

Batteries are fully
charged (fan off), and
the charger switches
between pulse-charge
and charge.

Flashing Green (Fast)

The charger is not
properly connected to
the batteries.

This manual is related to the following products: