Avery Dennison Sierra Sport4 9493 Quick Reference - Manual (Page 5)

5
P l a te n R o ll e r
L o a d i n g S u p p l i e s
1. Open the printer.
2. Remove the tape from a new roll of supply.
3. Push apart the supply holder tabs to widen the supply holder.
Insert a roll of supplies so it unwinds from the top.
4. Load supply for the print mode you want: non-peel, peel, or
fan-fold.
5. Press A under to advance
the supply after loading in all
modes.
F o r no n -pe e l m od e :
1. Pull out the supply so that a
few inches extend past the
front of the printer.
2. Center the supply across the
platen roller.
3. Close the printer.
F o r pe el m o d e:
1. Pull out the supply so that a
few inches extend past the front of the printer.
2. Raise the supply door back to
the upright position but do not close the printer.
3. Remove a couple of labels from the liner. Feed the liner over
the platen roller, over the peel bar, and under the peel edge.
Center the liner under the peel edge.
4. Close the printer completely.
5. Lightly tug on the liner to remove the slack.
P e el E d g e
L i n er
L a b e l