beautypg.com

Optional equipment, Decorative firebacks, Travis industries – Avalon Firestyles DVL Insert-1998 to 2001 User Manual

Page 37

background image

Optional Equipment

3 5

Travis Industries

4 0 1 1 0 2 5

9 3 5 0 8 1 0 4

Decorative Firebacks

(Part # - Brick Pattern 98500737, Classic Pattern 98500743)

!

Turn the gas control valve to "OFF" prior to conducting any service.

The decorative cast fireback attaches to the walls of the firebox to enhance aesthetics. Before
installing, remove the face, glass, logs, and embers. The directions below detail installation.

1

Remove the baffle at the top of the firebox following the directions below to the right.

Loose the two bolts at the back
of the firebox. Lift the baffle up
to remove it.

7/16" Wrench

Baffle

2

Install the firebacks following the
directions to the right.

3

Replace the baffle removed in
step 1.

a

b

Remove the screw on the back wall of the firebox.

c

Rest the upper rear fireback on top of the rear

fireback brace.

d

5/16" Nutdriver

Slide the rear fireback brace over the lower rear

fireback (note how the joggle tilts forward). Place

them against the back wall of the firebox and

attach with the screw removed in step a.

Secure the upper rear fireback by installing the upper rear fireback clip

over the bolts (do not tighten the bolts until the baffle is replaced).

The rear fireback rests on this ledge at the rear of the firebox.

Secure the side firebacks by attaching the fireback clips to the

firebox with the screws removed in step “e”.

Make sure the

notches on the side

firebacks fit into the

grooves on the

firebox floor.

Side Fireback Clip

Remove the screws on both

side walls of the firebox.

f

e