Avalon Firestyles DVL Insert-1998 to 2001 - Manual (Page 22)

2 0
Operation
Travis Industries
4 0 1 1 0 2 5
9 3 5 0 8 1 0 4
Before You Begin
! Read this entire manual before you use your new heater (especially the section "Safety Precautions"
on pages 2 & 3). Failure to follow the instructions may result in property damage, bodily injury, or even
death.
Location of Controls - See explanation below
Open the access door
to view the controls.
Gas Control Valve
PILOT ADJ
VENT
T O L PI
ON
OFF HI
LO
Gas Control Knob Flame Adjust Knob
An instruction card for operating the
fireplace is attached to the inside of the
fireplace here. Replace it for easy
reference.
PILOT
IGNITER
Pilot Igniter
BLOWER
CONTROL
LO
OFF
Blower Knob
HI
ON/OFF Switch
O
F
ON
F
The on/off switch is
located on the
upper right corner
of the surround
panels.
The Pilot Flame can be
found below the back log.
Blower Knob This knob controls the speed of the internal convection blower that pushes
the heated air into the room.
On/Off Switch This control is used to turn the heater on and off.
Pilot Igniter The pilot igniter is used only to start the pilot. When pressed, it sends an
electrical charge to the pilot assembly. This creates a blue spark directly next
to the pilot, igniting the pilot flame.
Gas Control Knob This knob is used to control gas to the heater and for starting the pilot. There
are three positions, ON, OFF, & PILOT. The pointer directly below the knob
indicates the position this knob is in.
Flame Adjust Knob This knob controls the flame height from low ("LO") to high ("HI"). The pointer
to the upper left of the knob points to the position this knob is in.
? If using a remote control or thermostat, the On/Off Switch must be left "ON". Turning the On/Off
Switch "OFF" will keep the heater off always.