beautypg.com

Safety label, Travis industries – Avalon Firestyles DVL Insert-1998 to 2001 User Manual

Page 30

background image

2 8

Safety Label

Travis Industries

4 0 1 1 0 2 5

9 3 5 0 8 1 0 4

The safety (listing) label is on a plate chained to the gas control valve. A copy of the safety label is
shown below.

DVL Insert

Vented Gas Direct-V

ent Fireplace Heater

Tested and certified by OMNI-T

est Laboratories, Inc. to the combustion performance and construction requirements of

ANSI Z21.88

/CSA

2.33-1998,

applicable sections of UL

307b and CAN/CGA

2.17-M91.

The DVL

Insert is equipped from the factory only for use with Natural Gas. For conversion to LP

(Propane) use kit supplied by the

manufacturer

. This appliance

must be installed in accordance with all local codes, if any; if not, in USA

follow

ANSI Z223.1-1992 and NFP

A

54(88), in Canada C

AN/CGA

B-149. Installation

in Manufactured or Mobile Homes must conform with: In USA, Manufactured Home Construction and Safety Standard, T

itle 24 CFR, Pa

rt 3280; In Canada,

CSA

Z240.4 and Gas-Equipped Recreational V

ehicles and Mobile Housing. This appliance is only for use with the type of gas indica

ted on the rating plate

and may be installed in an aftermarket, permanently located, manufactured (mobile) home where not prohibited by local codes. Se

e owner

’s

manual for

details. This appliance is not convertible for use with other gases, unless a certified kit supplied by the manufacturer is use

d. See owner

’s

manual for

information on making these changes. This appliance uses a millivolt-type control system consisting of a gas control valve/regu

lator

, a standing pilot burner

assembly

, a thermopile, a thermocouple, a piezo ignitor

, and the ON/OFF switch. THIS UNIT DOES NOT REQUIRE 1

10 VOL

T POWER T

O

OP

ERA

TE. All

exhaust gases must be vented outside the structure of the living-area. Combustion air is drawn from outside the living-area str

ucture.

This appliance is a V

ented Gas Fireplace Heater

. Not for use with Solid Fuel.

W

ARNING:

Improper installation, adjustment, alteration, service or maintenance can cause injury or property damage. Refer to the

owner

’s

information

manual provided with this appliance. For assistance or additional information consult a qualified installer

, service agency or

the gas supplier

.

W

ARNING: Operation of this appliance when not connected to a properly installed and maintained venting system can result in car

bon monoxide (CO)

poisoning and possible death.

Installation and repair should be performed by a qualified service person. The appliance should be inspected before use and at

least annually by a qualified

service person. More frequent cleaning may be required where excessive lint from material like carpeting and bedding is present

. The control compartment,

the burner compartment and all circulating air passageways of the appliance must be kept clean and clear at all times.

This appliance must be properly connected to a venting system in accordance with the manufacturer

’s

installation instructions.

This vented gas fireplace heater is not for use with air filters.

Due to high temperatures, the appliance should be located out of traffic and away from furniture and draperies.

Children and adults should be alerted to the hazards of high surface temperature and should stay away to avoid flesh burns or c

lothing ignition.

Young children should be carefully supervised at all times when they are in the same room as the appliance.

CAUTION:

Hot while in operation. Do not touch. Keep children, clothing, furniture, gasoline and other liquids having flammable vapors aw

ay

.

CAUTION:

Do not operate this appliance with glass removed, cracked or broken. Replacement of the panel(s) should be done by a li

censed or qualified service person.

10850 1

17th Pl. N.E. Kirkland, W

A

98033

Minimum Clearances to Combustibles

Faceplate to

Adjacent W

all
. . . . . . . . . . . . . . . .

6” (155mm)

Faceplate to Mantel (from top of insert face)

. . . . . . .

10” (255mm)

Hearth Extension in Front

. . . . . . . . . . . . . . . . .

12” (305mm)

Faceplate to Front Facing

. . . . . . . . . . . . . . . .

. . . . . . .

8.5” (215mm)

Hearth Extension to Sides of Faceplate

. . . . . .

0” (0mm)

Flue V

ent
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

. . . . . . .

See Owner

’s Manual

FAN TYPE VENTED CIRCULA

T

O

R

Blower Electrical Rating: 1

15 V

., 1.5

Amps, 60 Hz, 150 watts

Steady State Efficiency

. . . . . . .

Up to 81% (blowers on)

Output Capacity Rating

. . . . . . .

Up to 32,400 (blowers on)

L.P
.

N.G.

L.P
.
N.G.

Input Rate on “HI” (BTU/Hr)

............

40,000

40,000

Minimum Inlet Pressure (inches W

.C.)
...............

11.5”

5.5”

Input Rate on “LO” (BTU/Hr)

...........

20,000

20,000

Maximum Inlet Pressure (inches W

.C.)
..............

13”

7”

Maximum Output (BTU/Hr)

..............

32,400

31,200

Manifold Pressure on “HI” (inches W

.C.)

..........

11

3.5”

Main Burner Orifice (DMS)

..............

#49

#31

Manifold Pressure on “LO” (inches W

.C.)
.........

2.7”

1”

This appliance is equipped for installation in Canada at 0-4500 ft. (0-1370 m); in USA, 0-2000 ft. (0-610 m).

In USA, for altitudes above 2,000 feet, the vent configuration, orifice, or combination of both may need to be changed.

See the owner

’s

manual for information on making these changes.

Manufacture

1998

Jan.

Apr
.

Jul.

Oct.

Date:

1999

Feb.

May

Aug.

Nov

.

2000

Mar

.

Jun.

Sep.

Dec.

IGN

Report No. 028-S-21-1