Finalizing the installation, Travis industries – Avalon Firestyles DVL Insert-1998 to 2001 User Manual
Page 19

Finalizing the Installation
1 7
Travis Industries
4 0 1 1 0 2 5
9 3 5 0 8 1 0 4
?
If converting this unit to propane, do so now (see the instructions on page 30).
2
Install the log set, kibbles (optional), and embers (if using the decorative fireback, install it prior to the
log set - page 35).
Place the ember strips on
the grate as shown in this
illustration. The front
strip should hang half
way over the burner.
Grate
Place the log set on the
grate. Position the logs
so the rear corners rest
against the log stops.
Place the optional kibbles
in front of the firebox. Do
not place the kibbles directly
over the burner holes.
One Strip Approximately
7-1/2” by 1-1/2”
Two Strips Approximately
3” by 1-1/2”
Preparing the Glowing Embers:
The glowing embers comes in a single
strip. Stretch them as thin as possible
(nearly transparent) to form three strips
of the following sizes:
There may be extra material -
save it for future use.
Side View
Tuck the front of the ember strip down,
behind the burner with a screwdriver. Make
sure the mat of ember wool is not over the
burner holes. Tuck it behind the burner
tube if necessary.
Note how only a few
“whiskers” are over
the burner holes.