When connecting multiple infrared sensors – Audio Enhancement TLD100 User Manual

Page 24

When connecting multiple Infrared Sensors

Warning

• Before installing, be sure to turn off the power of the infrared sensor/receiver.

There is a risk of electric shock.

•

When connecting a single Infrared Sensor (EDS-07)

Connect the Infrared Sensor (EDS-07) to the EXT SENSOR connector of this unit. Set the No. 8 of the DIP switch
to OFF.

•

When connecting two or more Infrared Sensors (EDS-07) by utilizing the Infrared

Sensor Coupler (AE-DCF)

Using the Infrared Sensor Coupler (AE-DCF), it is possible to expand additional infrared sensors and to receive over a
much larger area.
When the infrared sensor coupler (AE-DCF) is utilized, make connections as shown in the illustration below.
Set the No. 8 of the DIP switch to ON.

Note:

• Improper setting of the DIP switch No. 8 may shorten the transmission range.

TLD100

EDS-07

Set the No. 8 of the DIP switch to OFF.

AE-DCF

EDS-07

TLD100

EDS-07

Coaxial cable

Set the No. 8 of the DIP switch to ON.