Audio Enhancement TLD100 - Manual (Page 11)

11
The installation should be carried out following local standards for electric products.
Warning
• Be sure to contact your dealer for installation.
Before installing, turn off the power of the connecting product. In addition, be sure to read "Precautions" carefully and
follow the instructions. Moreover, be sure to read operating instructions of the connecting product as well.
• Power
Connect the power plug of the AC adaptor by using a circuit breaker in any of the following ways:
Install this product near the power outlet.
Connect this product with the breaker of a distribution board which has a contact point of not less than 3.0 mm
{3/32 inches}.
Use a breaker that can block all the poles except for protective earth conductors.
Connect this product via the outlets of devices that can block power such as a power control unit.
• Static Electricity
Discharge any static electricity charged in your body by touching a metallic area before installing in order to prevent
damage caused by static electricity.
• Install the infrared sensor within a range that the microphone can reach and in a location that can be
seen in moving range.
• Be sure the connector and coaxial cable are connected in the correct way.
If the process and connection are incomplete, receiving sensitivity may be reduced and product will be more easily
affected by external noises.
• Do not install in locations where strong light or sunlight strikes the infrared sensor directly.
If the product is installed near a window, the product is subject to the solar light even if the solar light does not strike
it directly, which may reduce the receiving sensitivity and shorten the range. Install the product as far from strong light
as possible (more than 5 m {16 feet}). If the situation is still not improved, it may be better to install it farther from
window side or use a curtain or window shade.
• Avoid installing near a warm air flow path. In addition, if the product is installed in locations with an
abundance of moisture, dust or vibration, there is a risk of damage.
• In locations with a large amount of dust, the dust may accumulate on the Infrared Sensor Cover, which
may interfere with reception of the infrared signal. As a result, the range may be reduced. Therefore,
avoid installing in locations with a lot of dust.
• Do not install and use in following locations:
① Locations directly affected by rain or water (including spaces under the eaves).
② Locations such as a pool where medical agents are used.
③ Locations such as a kitchen or factory workshop where there is a lot of vapor or oil and special environments such
as in flammable atmospheres.
④ Locations where radiation or X-rays and strong electric fields or magnetism arise.
⑤ At sea or along the coast, and locations such as hot springs where corrosive gases arise.
⑥ Locations with a lot of vibrations caused by large vehicles or ships (this is not a product for vehicles).
⑦ Locations where water drops made by condensation will splash.
Precautions for installation