Audio Enhancement TLD100 - Manual (Page 19)

19
Connection of sensor/receiver
•
LINE IN connection
Connect the audio output of a projector, CD player, DVD/VCR or similar line level output to the LINE IN L/R connector of
the dome sensor/receiver. The line input of this terminal is a stereo input. Audio signals are mixed to monaural signals
internally. Cables should be selected depending on the connector types of devices to be connected and follow the
description below to connect external devices.
•
Connection with the conversion box
The TO CONVERSION BOX connector of this unit shall be connected to the TO RECEIVER connector (RJ-45) of the
conversion box. Use a commercially available LAN cable (CAT5 or similar) as a connection cable.
30 m {100 feet} is the maximum connectable distance.
Note:
•
•
An RJ-45 type connector of this unit is based on our original system and electrical specifications. Never connect this
terminal to a LAN connector that is compatible with Ethernet and PoE (Power over Ethernet).
Never connect this connector to a LAN connector that is compatible with Ethernet and PoE (Power over Ethernet).
Be sure to make a connection when the power of this unit is set to OFF. (No AC adaptor is allowed to be connected to
the conversion box.)
If making an unbalanced connection for an audio output of this unit, use a STP (Shield Twisted Pair) LAN cable to
prevent extraneous noise.
Connections
LINE IN L/R
Stereo mini-plug ø3.5 mm {1/8 inches}
Stereo mini-plug ø3.5 mm {1/8 inches}
Pin plug
LEFT
RIGHT
TIP: LEFT
RING: RIGHT
SLEEVE: GND
Stereo mini-plug ø3.5 mm {1/8 inches}
External device
Projector, DVD or
CD player, VCR, etc.
LAN cable max. 30 m {100 feet}
Conversion box
[TO RECEIVER]
Sensor/receiver
[TO CONVERSION BOX]