Audio Enhancement TLD100 - Manual (Page 10)

10
Operating procedures
1 Insert the plug of the supplied AC adaptor into
the wall outlet.
The operation LED of the sensor/receiver lights green.
2 Turn on the power switch of the microphone.
(MTD-09, MHH-09)
The reception LED indicator of the sensor/receiver
lights green depending on a channel to be received.
3 Adjust the volume of external devices such as
an amplifier.
The overall volume is adjusted with an amplifier or
another external device. Use of the volume button of
MTD-09 allows the volume of itself to be adjusted. In
addition, selection of the target with the selection
button of the MTD-09 allows the volume of the other
microphone received by this unit and the volume of
LINE IN of this unit to be adjusted.
4 The LED of the sensor/receiver indicates the
operating state of this unit during operation.
Refer to page 16 for further information.
LED of sensor/receiver
Operation indicator Reception indicator /
F2 signal output provided* Red light Red light
(Green light at F2 ACK input
provided)
F1 signal output provided* Green light Red light (for 300 ms)
Page mute signal input provided Yellow light Yellow light
Microphone volume operated* Green light No light (for 300 ms)
Feedback blocker operated Green light Yellow light (for 5 s)
* Applicable when MTD-09 is used
Note:
• Read the operating instructions of the microphones (MTD-09, MHH-09) as well.
• The volume adjusted with the volume button of the microphone retains its level even if the power is turned off.
Operation indicator
Microphone CH2
Microphone CH1
ON
MHH-09 MTD-09
CH G
PW R
F
BATT
SEL
EC T
O WN OT HE R L
INE
M U TE
Power indicator
Power switch
CH G
PW R
F
BATT
SE LEC
T
O WN OT HE R LI NE
M U TE
Selection indicator
Selection button
Volume buttons
TLD100
TLD100
MTD-09
2 1