Dolby Laboratories SDV-27 - Manual (Page 34)

34
Playback functions
Loading
1 Press OPEN button to open.
(If no disk is in place, the tray will open
automatically after power on.)
2 Without a power supply, the tray will not open
automatically; you must insert the open-stick into
the hole to open it.
3 Position disc and press down the disc with your
fingers near the centre hole.
A click is heard.
Notes:
ƒ
Set the disc securely. Failure to set it securely
could result in damage.
ƒ Do not use cracked or warped discs. Doing so
could result in damage.
ƒ Position single-sided DVDs or CDs with the label
(printed) side facing upwards. For double-sided
DVDs, check each side carefully, then position the
disc securely (until a click is heard).
ƒ For CDs or single-sided DVDs, you do not have to
worry about touching the label (printed) side of the
disc with your fingers. Since double-sided DVDs,
however, have signals recorded on both sides, be
careful not to scratch them when removing them
from the player.
4 Push the tray into the player.
The player starts loading.