Artesyn ViewCheck on ATCA-9405 Installation and Use (November 2014) - Manual (Page 43)

Chapter 4
ViewCheck on ATCA-9405 Installation and Use (6806800S51F) 43
Commands Execution
4.1 Overview
CLI and XML are the primary ways to access ViewCheck capabilities on the blade. These
mechanisms allow you to perform activities such as start, stop, and query on the ViewCheck
software. Using CLI and XML, you can also set the parameters for monitoring.
Commands are classified into:
 Generic commands
 Commands for test management and control
 Commands for monitoring
4.2 Generic Commands
This section describes the generic commands of ViewCheck service.
4.2.1 configure-error-strings
configure-error-strings
command allows to add user-defined kernel error strings to
the diagnostics database.
Syntax for CLI
configure-error-strings errorStrings
The command syntaxes for XML interface is given for the diagnostic class with instance
as vee0. This instance varies depending on the blade.