Artesyn ViewCheck on ATCA-9405 Installation and Use (November 2014) - Manual (Page 24)

Installation of ViewCheck
ViewCheck on ATCA-9405 Installation and Use (6806800S51F) 24
To uninstall the BSF, execute the following RPM commands:
 rpm -e ssf_diagnosticsTLS_rel---
..rpm

rpm -e ssf_csim_rel---..rpm
 rpm -e ssf_main_rel---..rpm
3.4 ViewCheck Service OS Image
The ViewCheck Service OS Image enables you to boot into ViewCheck specific OS and execute
the OOSD tests. The ViewCheck service is not completely dependent on the blade BBS
environment. For compatibility purpose, it may use the same OS or the Kernel variant that are
used by the blade BBS service. For ATCA-9405 SP, the ViewCheck service OS is created with PNE
4.1 as the OS. For ATCA-9405 PP the OOSD image is built from cavium Software Development
Kit (SDK). The ATCA-9405 PP OOSD image is packaged along with ATCA-9405 SP OOSD image.
So there is a single ViewCheck OS image for ATCA-9405 blade.
The ViewCheck service OS along with the ViewCheck RPM, test suites, and test procedures are
distributed as an ISO file that contains:
 ViewCheck OS as Ram Disk image that can be Net bootable.
 ViewCheck OS image can be Net bootable and installable on selected Flash partition,
provided User Flash is available on the blade.
Before performing uninstallation, stop the BSF services using below script.
/opt/ssf/etc/config/S99SsfBsfRun.sh stop
The order of removal of RPMs is a reverse procedure to that of installation.