Artesyn ViewCheck on ATCA-9405 Installation and Use (November 2014) - Manual (Page 30)

Installation of ViewCheck
ViewCheck on ATCA-9405 Installation and Use (6806800S51F) 30
show-test-result Show test result
show-test-status Show test status
show-upper-threshold-info Show upper threshold info.
start-monitor Start a monitor
start-test Start a test
stop-monitor Stop a monitor
stop-test Stop a test
After logging into the CLI, you can start, stop, and query a test from the CLI. You can view the
details of the test by executing show-test-help command.
To start a test, you can run start-test command with testId, deviceInstance, and
arguments as input to the command. The arguments can be neglected for tests that does not
take any argument as input.
After test execution, the results can be viewed by show-test-result command, which
displays test result and a raw log generated by that test.
Using CLI, you can list all the InService diagnostics monitors in a device category. By default, all
monitors start when ViewCheck application is initialized. You can start and stop any monitor
using start-monitor and stop-monitor commands.
To exit from the ViewCheck CLI:
BSF(diag-SP_VEE0)#exit
BSF(VEE-vee0)#exit
BSF(config)#exit
#exit
3.6 Access and Execution of a Test Using XML
You can access ViewCheck XML interface similar to ViewCheck CLI.
1. Establish the secure shell using SSH or Putty.
2. Start the Telnet connection from an already established secure shell.