Artesyn ViewCheck on ATCA-9405 Installation and Use (November 2014) - Manual (Page 27)

Installation of ViewCheck
ViewCheck on ATCA-9405 Installation and Use (6806800S51F) 27
Trying 127.0.0.1...
Connected to localhost.localdomain (127.0.0.1).
Escape character is '^]'.
Welcome to Emerson's SSF CLI
3. Type your username and password.
Username: Admin
Password:
Access granted
>enable
#configure terminal
BSF(config)#
4. Select Virtual Execution Environment as below:
 On SP, use the virExecEnv SP_VEE0 options in the virExecEnv.
BSF(config)#virExecEnv virExecEnv SP_VEE0
BSF(VEE-SP_VEE0)#diagnostic
BSF(diag-SP_VEE0)#
 On PP, use the OCTEON1_VEE0/OCTEON1_VEE1 options in the virExecEnv.
BSF(config)#virExecEnv OCTEON1_VEE0
BSF(VEE-OCTEON1_VEE0)#diagnostic
BSF(diag-OCTEON1_VEE0)#
After logging into the ViewCheck CLI, you can list all supported commands by typing '?' on
the CLI console. Following is an example.
BSF(diag-SP_VEE0)#?
configure-error-strings User configurable error strings, notified
by ViewCheck when reported by the device.
configure-log-path Configures the log path where the resluts
are stored.
device-category Configure deviceCategory
By default, the administrator user name and password are "Admin".